V Belts and Pulleys
$5.00 – $12.00
Check out our new selection of 6mm wide V belts and pulleys designed specifically for 3lb robot weapon systems!
Tried and tested on Knuckle Sandwich and Repeater, these belts can take hits while protecting your motor from shock loading!
These weapon systems are specifically designed to be near a drop in solution for your standard FTBB weapon system.
Description
Motor Side Pulleys
Type A
- Comes in 1/8″ or 4mm bore
- Dual M4 set screws outside the pulley groove
- Longer design works best with outrunner motors
- 7.8g weight
Type B
- Comes in 1/8″ or 4mm bore
- Dual M3 set screws in the pulley groove
- Low profile design works better with most common FTBB layouts
- 6g weight
Weapon Side Pulleys
FTBB 36mm Pulley
- 36mm pitch diameter
- Keys into the FTBB bar
- Comes with a stepped bore to allow fitting an extra large needle bearing (SCE59)
- Can be countersunk, or work with the Delrin flange on common FTBB designs
- 25.7g weight
V Belts
220mm V Belt
- 220 mm outer diameter
- 6mm width
- Cogged V belt
- 3.9g weight
NOTE: V belts require correct tension in order to work. This means you should have some way of adjusting tension to keep correct tension as the belts stretch over time.
Find 3 models here: https://grabcad.com/library/assorted-v-belt-pulleys-1
Additional information
| Weight | N/A |
|---|---|
| Type | Motor – Type A – 1/8" Bore, Motor – Type A – 4mm Bore, Motor – Type B – 1/8" Bore, Motor – Type B – 4mm Bore, FTBB 36mm Pulley, 220mm V Belt |
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.