Description

Gearbox:

• 19:1 ratio
• 1/2in hex shaft to fit common accessories
• Billet final carrier and output shaft made from hardened 4140 steel
• M6 end tap on shaft for retaining
• Dual 6902 15mm ID bearings
• 4x M5 mounting holes on top/bottom of the gearbox
• 5mm bore pinion (comes with 1x pinion)
• Designed for 35xx outrunners or 36xx inrunners with 17mm shaft length.
• ~250g weight
• BLACK  A E S T H E T I C
• Comes pre-greased

3D Model: https://grabcad.com/library/repeat-drive-magnum-gearbox-1

Gearmotor:

Now takes the guesswork out of mating a motor to the repeat magnum.

• Comes with a 3536 mated to the gearbox
• 1400kv for use up to 6S
• 345g weight with wires and connectors

Pairs great with our new 50A AM32 drive esc: https://repeat-robotics.com/buy/big-bot-drive-esc-50a-am32/

Re-greasing is recommended for high input speeds. Running the gearbox with stock grease at high rpms can cause unwanted thermal effects that will cause your motors to draw more current and run less efficiently.

Check out our related products below:

Spare gearbox shafts: https://repeat-robotics.com/buy/repeat-drive-magnum-replacement-shaft/

Spare pinion gears: https://repeat-robotics.com/buy/repeat-magnum-spare-pinion-gear/

Spare ring gears: https://repeat-robotics.com/buy/repeat-drive-magnum-replacement-ring-gear/