Description

Tech specs:

• Donor motor size: 2207.5
• Comes with battle hardened magnet ring
• Weight:
  • 55g without wires
  • 59g with full length wires
  • 65g with blade mounting hardware
  • 79g with 0.25 x 1.5″ shoulder bolt and locknut (for .25″ uprights)
• Massive 6704 and 698 bearings
• M3x16mm motor mount pattern
• M4 weapon mount screws
• Can mount blade on the end or the center of the motor
• Works with blades from 1/8” thick to 3/8” thick.
• Overall dimensions: 1.73in max diameter by 1in length
• 3 kv options: 1200, 1800, 2400
• Recommended for 3S and 4S usage, but 1200kv motor can be run on 6S with a small enough weapon

Notes for use:

• 1/4″ shoulder bolt or other similar through shaft is required for use. Without the shoulder bolt the rotor is not fully constrained and may be damaged.
• 1/4″ x 1.5″ shoulder bolt is great for bots with 2x 0.25″ uprights.
• When designing the blade, the tooth portion should line up with the 2 screws at the top. This provides the most optimal loading scenario with maximum strength. Three tooth weapon designs are not recommended.

The motors have been tested on the following bots:

• Agitation – Vert
• Baby Nautiloid – Vert
• Juice – Undercutter
• Mudskipper – Undercutter
• Andrew’s Malice – Horizontal
• Outlier – Horizontal
• RUDE – Vert
• Milk Teeth – Vert

Find the 3D model here: https://grabcad.com/library/2207-battle-ready-hubmotor-1

Find blades available for purchase here: https://repeat-robotics.com/buy/hubmotor-weapon-blades/

Works great with our 35A weapon esc: https://repeat-robotics.com/buy/readytosky-35a-blheli_s-ant-weapon-esc/